Abstract
This study proposes a microfabricated resonant pressure sensor in which a pair of double-ended tuning forks were utilized as resonators where comb electrodes and single-crystal silicon-based piezoresistors were used for electrostatic excitation and piezoresistive detection, respectively. In operations, pressures under measurements deform the pressure-sensitive diaphragm to cause stress variations of two resonators distributed on the central and side positions of the pressure-sensitive diaphragm, where the corresponding changes of the intrinsic resonant frequencies are then captured piezoresistively. The developed resonant pressure sensors were fabricated based on MEMS with open-loop and closed-loop characterizations conducted. Key sensing parameters including quality factors, differential pressure/temperature sensitivities and fitting errors were quantified as higher than 17,000, 48.24 Hz/kPa, 0.15 Hz/°C and better than 0.01% F.S. (140 kpa), respectively. In comparison to previously reported resonant pressure sensors driven by parallel-plate electrodes, the developed sensor in this study is featured with a lower temperature sensitivity and a higher stability.
Funder
National Key Research and Development Program
the National Natural Science Foundation of China
Subject
Electrical and Electronic Engineering,Mechanical Engineering,Control and Systems Engineering
Cited by
10 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献