Effects of Mean Inflow Velocity and Droplet Diameter on the Propagation of Turbulent V-Shaped Flames in Droplet-Laden Mixtures

Abstract

Three-dimensional carrier phase Direct Numerical Simulations of V-shaped n-heptane spray flames have been performed for different initially mono-sized droplet diameters to investigate the influence of mean flow velocity on the burning rate and flame structure at different axial locations from the flame holder. The fuel is supplied as liquid droplets through the inlet and an overall (i.e., liquid + gaseous) equivalence ratio of unity is retained in the unburned gas. Additionally, turbulent premixed stoichiometric V-shaped n-heptane flames under the same turbulent flow conditions have been simulated to distinguish the differences in combustion behaviour of the pure gaseous phase premixed combustion in comparison to the corresponding behaviour in the presence of liquid n-heptane droplets. It has been found that reacting gaseous mixture burns predominantly under fuel-lean mode and the availability of having fuel-lean mixture increases with increasing mean flow velocity. The extent of flame wrinkling for droplet cases has been found to be greater than the corresponding gaseous premixed flames due to flame-droplet-interaction, which is manifested by dimples on the flame surface, and this trend strengthens with increasing droplet diameter. As the residence time of the droplets within the flame decreases with increasing mean inflow velocity, the droplets can survive for larger axial distances before the completion of their evaporation for the cases with higher mean inflow velocity and this leads to greater extents of flame-droplet interaction and droplet-induced flame wrinkling. Mean inflow velocity, droplet diameter and the axial distance affect the flame brush thickness. The flame brush thickens with increasing droplet diameter for the cases with higher mean inflow velocity due to the predominance of fuel-lean gaseous mixture within the flame. However, an opposite behaviour has been observed for the cases with lower mean inflow velocity where the smaller extent of flame wrinkling due to smaller values of integral length scale to flame thickness ratio arising from higher likelihood of fuel-lean combustion for larger droplets dominates over the thickening of the flame front. It has been found that the major part of the heat release arises due to premixed mode of combustion for all cases but the contribution of non-premixed mode of combustion to the total heat release has been found to increase with increasing mean inflow velocity and droplet diameter. The increase in the mean inflow velocity yields an increase in the mean values of consumption and density-weighted displacement speed for the droplet cases but leads to a decrease in turbulent burning velocity. By contrast, an increase in droplet diameter gives rise to decreases in turbulent burning velocity, and the mean values of consumption and density-weighted displacement speeds. Detailed physical explanations have been provided to explain the observed mean inflow velocity and droplet diameter dependences of the flame propagation behaviour.