Aerodynamic Free-Flight Conditions in Wind Tunnel Modelling through Reduced-Order Wall Inserts

Abstract

Parallel sidewalls are the standard bounding walls in wind tunnels when making a wind tunnel model for free-flight condition. The consequence of confinement in wind tunnel tests, known as wall-interference, is one of the main sources of uncertainty in experimental aerodynamics, limiting the realizability of free-flight conditions. Although this has been an issue when designing transonic wind tunnels and/or in cases with large blockage ratios, even subsonic wind tunnels at low-blockage-ratios might require wall corrections if a good representation of free-flight conditions is intended. In order to avoid the cumbersome streamlining methods especially for subsonic wind tunnels, a sensitivity analysis is conducted in order to investigate the effect of inclined sidewalls as a reduced-order wall insert in the airfoil plane. This problem is investigated via Reynolds-averaged Navier–Stokes (RANS) simulations, and a NACA4412 wing at the angles of attack between 0 and 11 degrees at a moderate Reynolds number (400 k) is considered. The simulations are validated with well-resolved large-eddy simulation (LES) results and experimental wind tunnel data. Firstly, the wall-interference contribution in aerodynamic forces, as well as the local pressure coefficients, are assessed. Furthermore, the isolated effect of confinement is analyzed independent of the boundary-layer growth. Secondly, wall-alignment is modified as a calibration parameter in order to reduce wall-interference based on the aforementioned assessment. In the outlined method, we propose the use of linear inserts to account for the effect of wind tunnel walls, which are experimentally simple to realize. The use of these inserts in subsonic wind tunnels with moderate blockage ratio leads to very good agreement between free-flight and wind tunnel data, while this approach benefits from simple manufacturing and experimental realization.