Dosimetry and Calorimetry Performance of a Scientific CMOS Camera for Environmental Monitoring

Abstract

This paper explores the prospect of CMOS devices to assay lead in drinking water, using calorimetry. Lead occurs together with traces of radioisotopes, e.g., 210Pb, producing γ-emissions with energies ranging from 10 keV to several 100 keV when they decay; this range is detectable in silicon sensors. In this paper we test a CMOS camera (Oxford Instruments Neo 5.5) for its general performance as a detector of X-rays and low energy γ-rays and assess its sensitivity relative to the World Health Organization upper limit on lead in drinking water. Energies from 6 keV to 60 keV are examined. The CMOS camera has a linear energy response over this range and its energy resolution is for the most part slightly better than 2%. The Neo sCMOS is not sensitive to X-rays with energies below ∼10 keV. The smallest detectable rate is 40±3mHz, corresponding to an incident activity on the chip of 7±4Bq. The estimation of the incident activity sensitivity from the detected activity relies on geometric acceptance and the measured efficiency vs. energy. We report the efficiency measurement, which is 0.08(2)% (0.0011(2)%) at 26.3keV (59.5keV). Taking calorimetric information into account we measure a minimal detectable rate of 4±1mHz (1.5±1mHz) for 26.3keV (59.5keV) γ-rays, which corresponds to an incident activity of 1.0±6Bq (57±33Bq). Toy Monte Carlo and Geant4 simulations agree with these results. These results show this CMOS sensor is well-suited as a γ- and X-ray detector with sensitivity at the few to 100 ppb level for 210Pb in a sample.