Multi-Criteria Optimisation of Friction Stir Welding Parameters for EN AW-2024-T3 Aluminium Alloy Joints

Abstract

The aim of this research was the selection of friction stir welding (FSW) parameters for joining stiffening elements (Z-stringers) to a thin-walled structure (skin) made of 1 mm-thick EN AW-2024 T3 aluminium alloy sheets. Overlapping sheets were friction stir welded with variable values of welding speed, pin length (plunge depth), and tool rotational speed. The experimental research was carried out based on a three-factor three-level full factorial Design of Experiments plan (DoE). The load capacity of the welded joints was determined in uniaxial tensile/pure shear tests. Based on the results of the load capacity of the joint and the dispersion of this parameter, multi-criteria optimisation was carried out to indicate the appropriate parameters of the linear FSW process. The optimal parameters of the FSW process were determined based on a regression equation assessed by the Fisher–Senecor test. The vast majority of articles reviewed concern the optimisation of welding parameters for only one selected output parameter (most often joint strength). The aim of multi-criteria optimisation was to determine the most favourable combination of parameters in terms of both the smallest dispersion and highest load capacity of the joints. It was found that an increase in welding speed at a given value of pin length caused a decrease in the load capacity of the joint, as well as a significant increase in the dispersion of the results. The use of the parameters obtained as a result of multi-criteria optimisation will allow a minimum load capacity of the joints of 5.38 kN to be obtained with much greater stability of the results.