Changes in Abrasion Resistance of Cast Cr-Ni Steel as a Result of the Formation of Niobium Carbides in Alloy Matrix

Abstract

Cast austenitic chromium-nickel steel is commonly used for the manufacture of machine parts and components, which are exposed to the attack of corrosive media and abrasive wear during operation. The most commonly used grades include GX2CrNi18-9 and X10CrNi18-8 as well as GX2CrNiMo17-12-2 and X6CrNiMoNb17-12-2. To improve the abrasion resistance of cast chromium-nickel steel, primary niobium carbides were produced in the metallurgical process by increasing the carbon content and adding Fe-Nb. The microstructure of the obtained test castings consisted of an austenitic matrix and primary niobium carbides evenly distributed in this matrix. The measured hardness of the samples after heat treatment ranged from 215 to 240 HV and was higher by about 60 units than the hardness of the reference cast GX10CrNi18-9 steel, which had a hardness of about 180 HV. Compared to the reference cast steel, the abrasive wear resistance of the tested cast chromium-nickel steel (measured in Miller test) with contents of 4.4 and 5.4 wt% Nb increased only slightly, i.e., by 5% for the lower niobium content and 11% for the higher niobium content. Compared to ordinary cast GX10CrNi18-9 steel, the addition of 9.2 wt% Nb reduced the abrasive wear by almost 2.5 times.