Study on the SPCC and CFRTP Hybrid Joint Performance Produced with Additional Nylon-6 Interlayer by Ultrasonic Plastic Welding

Abstract

Due to the high degree of dissimilarity in physicochemical properties between metal and carbon fiber, it presents a tremendous challenge to join them directly. In this paper, cold rolled steel (SPCC) and carbon fiber reinforced thermoplastic (CFRTP) chopped sheet hybrid joints were produced with the addition of Nylon 6 (PA6) thermoplastic film as an intermediate layer by the ultrasonic plastic welding method. The effect of ultrasonic welding energy and preheating temperature on the hybrid joint microstructure and mechanical behavior was well investigated. The suitable joining parameters could obtain a strong joint by adding the PA6 film as an intermediate layer between the SPCC and bare carbon fibers. Microstructural analysis revealed that the interface joining condition between the PA6 film and the SPCC component is the primary reason for the joint strength. The crevices generated at the interface were eliminated when the preheating temperature arrived at 200 °C, and the joint strength thus significantly increased. The lap shear test results under quasi-static loading showed that the welding energy and preheating temperature synergistically affect the joint performances. At 240 °C, the joint strength value reached the maximum. Through the analysis of the microstructure morphology, mechanical performance, and the failure mechanism of the joint, the optimized joining process window for ultrasonic plastic welding of SPCC-CFRTP by adding an intermediate layer, was obtained.