Dynamic Response and Deformative Mechanism of the Shape Memory Polymer Filled with Low-Melting-Point Alloy under Different Dynamic Loads

Abstract

Low-melting-point alloy (LMPA) was used as an additive to prepare epoxy-resin-based shape memory polymer composites (LMPA/EP SMP), and dynamic mechanical analyzer (DMA) tests were performed to demonstrate the shape memory effect, storage modulus, and stiffness of the composites under different load cases. The composites exhibited an excellent shape recovery ratio and shape fixity ratio, and a typical turning point was observed in the storage modulus curves, which was attributed to the melting of the LMPA. In order to investigate the dynamic deformation mechanism at high strain rates, split Hopkinson pressure bar (SHPB) experiments were performed to study the influence of the strain rate and plastic work on the dynamic mechanical response of LMPA/EP composites. The results showed that there was a saturated tendency for the flow stress with increasing strain rate, and the composites exhibited a typical brittle failure mode at high strain rate. Moreover, an obvious melting phenomenon of the LMPA was observed by SEM tests, which was due to the heat generated by the plastic work at high strain rate. The fundamental of the paper provided an effective approach to modulate the stiffness and evaluate the characteristics of SMP composites.