Comparison of the Combustion Process Parameters in a Diesel Engine Powered by Second-Generation Biodiesel Compared to the First-Generation Biodiesel

Abstract

The use of biofuels to power compression–ignition engines makes it possible to reduce emissions of certain harmful components of exhaust gases. The purpose of this study was to determine the influence of second-generation biofuels on the course of indicator graphs and heat release characteristics of the Perkins 1104D-44TA compression–ignition engine. For comparative purposes, the same tests were carried out by feeding the engine with first-generation biofuel and diesel fuel. Babassu butyl esters (BBuE) were used as the second-generation biofuel. The second fuel was a first-generation biofuel—rapeseed oil methyl esters (RME). Analysis of the results made it possible to draw conclusions about the effect of using 2nd and 1st generation biofuels on the parameters of the combustion process. When the DF engine was powered, the lowest fuel dose per work cycle was obtained. In the case of RME and BBuE fuels, it depends on the engine load. For low loads, higher consumption is for RME, and for higher loads, fuel consumption for BBuE in-creases most often. This is due to the lower calorific value of the esters. The results of these tests indicate that feeding the engine with BBuE and RME fuel in most loads resulted in higher maximum combustion pressures compared to feeding the engine with DF which may be directly related to the higher cetane number of these fuels compared to DF and the oxygen content of these fuels. Feeding the engine with BBuE and RME esters compared to DF did not result in large differences in the maximum heat release rates HRmax. However, the values of the first and second maximum heat release rates x1max and x2max, in addition to the type of fuel, are strongly influenced by the operating conditions, especially the engine load. Analyzing the combustion angles of 5, 10, 50, and 90% of the fuel dose, it can be seen that feeding the engine with BBuE and RME esters for most measurement points results in faster combustion of the fuel dose compared to DF.