Abstract
Wearable devices require power management systems to achieve high conversion efficiency over a wide range of load currents. Multi-mode mixed modulation can be used in DCDC converters to achieve high efficiency over a wide load current range. The DCDC boost converter proposed in this paper uses a hybrid modulation of DGM (Deep Green Control Mode), PCMC (Peak current mode control)-PFM (Pulse Frequency Modulation) and PCMC-PWM (Pulse Width Modulation). The converter switches smoothly from PCMC-PFM to PCMC-PWM mode under load-current-based conditions and without any mode selection module. The proposed DCDC boost converter is fabricated in a 0.18 μm CMOS process with a Die area of 1.24 × 0.78 μm2. The input voltage range is 0.8–5 V, the output voltage is 5 V, and the load current range is 5–300 mA. Experimental results show that the boost converter can achieve 94.7% peak efficiency. Efficiency of more than 90% can be achieved in the load current range of 30–300 mA.
Subject
Electrical and Electronic Engineering,Computer Networks and Communications,Hardware and Architecture,Signal Processing,Control and Systems Engineering
Reference28 articles.
1. IMARC Group
2. A Survey of Wearable Devices and Challenges
3. Introduction to Wearable Computers;Motti,2020
4. Applications of Wearable devices in IoT;Jain;Proceedings of the 2021 9th International Conference on Reliability, Infocom Technologies and Optimization (Trends and Future Directions) (ICRITO),2021
5. ReadWrite
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献