Affiliation:
1. Instituto Nacional de Astrofísica, Óptica y Electrónica (INAOE), Tonantzintla, Puebla 72840, Mexico
Abstract
In this paper, we present a dual-band antenna working at 2.45 GHz and 5.8 GHz. The design is based on two radiating rectangular slots with one upper Split Ring Resonator (SRR) to enhance the radiation pattern at 5.8 GHz, one Complementary Split Ring Resonator (CSRR), and three Split Rings (SR) to improve the input reflection coefficient. The dual-band antenna covers the 2.45 GHz and 5.8 GHz Industrial, Scientific and Medical (ISM) bands. The total size of the proposed antenna is 31 × 70 × 70 mm3. The proposed antenna was manufactured and tested. The attained gain is better than 7.5 dBi, and 6.5 dBi at 2.4 GHz and 5.8 GHz, respectively. The measured gain and input reflection coefficient have good correlation with the simulated results, covering the ISM bands around 2.45 GHz and 5.8 GHz. The performance of the proposed antenna is remarkable and suitable for applications where the size is not a severe limitation, such as sensors, LPWAN/WLAN modules, health care devices, base stations, IoT, and control applications.
Funder
Mexican National Council for Science and Technology
Subject
Electrical and Electronic Engineering,Computer Networks and Communications,Hardware and Architecture,Signal Processing,Control and Systems Engineering
Reference31 articles.
1. A Low-Cost 3-D Printed THz Open Resonator Antenna;Li;IEEE Antennas Wirel. Propag. Lett.,2023
2. Aperture-Shared All-Metal End-Fire High Gain Parabolic Antenna for Millimeter-Wave Multi-Beam and Sub-6 GHz Communication Applications;Zhu;IEEE Trans. Antennas Propag.,2023
3. Wang, J., and Xu, J. (2004, January 10–13). Environmental implications of PCB manufacturing in China. Proceedings of the IEEE International Symposium on Electronics and the Environment, Scottsdale, AZ, USA.
4. Uzer, D., and Cubuk, S. (2022, January 14–17). Three-Dimensional Printed Helical Antenna Compatible with Rotary Wing Unmanned Aerial Vehicles. Proceedings of the 2022 IEEE Conference on Antenna Measurements and Applications (CAMA), Guangzhou, China.
5. Antenna Design Using Modern Additive Manufacturing Technology: A Review;Helena;IEEE Access,2020
Cited by
4 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献