Wireless Power Transfer System with Current-Doubler Rectifier on the Secondary Side—Analysis, Modeling, and Verification
-
Published:2023-11-28
Issue:23
Volume:12
Page:4818
-
ISSN:2079-9292
-
Container-title:Electronics
-
language:en
-
Short-container-title:Electronics
Author:
Kindl Vladimir1, Zavrel Martin1, Tyrpekl Miroslav1, Frivaldsky Michal2ORCID, Skorvaga Jakub2
Affiliation:
1. Faculty of Electrical Engineering, West Bohemian University, 301 00 Pilsen, Czech Republic 2. Faculty of Electrical Engineering and Information Technologies, University of Zilina, 010 08 Zilina, Slovakia
Abstract
In this paper, the proposal for the performance optimization of the wireless power transfer (WPT) system is given. The solution is based on the alternative configuration of the secondary-side rectifier. It is represented by a diode rectifier with a current doubler. Compared to the bridge rectifier, two diodes are replaced by the inductors. Initially, a system analysis was performed to investigate the electrical behavior and find the most optimal conditions referred to as terms of efficiency performance at nominal power. Due to this requirement, the rectifier inductors must be designed accordingly to meet this condition. The experimental verification was realized as well, while the proposed solution was compared to other common alternatives of the secondary-side rectification. The load sensitivity analysis in terms of efficiency performance was realized as well to observe the system behavior for a wide operation range. From the results, it is seen that the proposed alternative of the secondary-side rectification of the WPT system gives promising results in terms of high operating efficiency.
Funder
University of West Bohemia VEGA Ministry of Education, Youth and Sports of the Czech Republic
Subject
Electrical and Electronic Engineering,Computer Networks and Communications,Hardware and Architecture,Signal Processing,Control and Systems Engineering
Reference45 articles.
1. Rim, C.T. (2018). Power Electronics Handbook, Butterworth-Heinemann. [4th ed.]. 2. Van Mulders, J., Delabie, D., Lecluyse, C., Buyle, C., Callebaut, G., Van der Perre, L., and De Strycker, L. (2022). Wireless Power Transfer: Systems, Circuits, Standards, and Use Cases. Sensors, 22. 3. Tran, M.T., Thekkan, S., Polat, H., Tran, D.-D., El Baghdadi, M., and Hegazy, O. (2023). Inductive Wireless Power Transfer Systems for Low-Voltage and High-Current Electric Mobility Applications: Review and Design Example. Energies, 16. 4. Houran, M.A., Yang, X., Chen, W., Hanif, A., Hassan, A., and Qin, M. (2021, January 10–14). Wireless Power Transfer System for Automatic Revolving Doors. Proceedings of the 2021 IEEE Energy Conversion Congress and Exposition (ECCE), Vancouver, BC, Canada. 5. Jena, S., Sahu, P.K., and Mohapatra, S.K. (2021). Electronic Devices, Circuits, and Systems for Biomedical Applications, Academic Press.
|
|