A BLE 5.0 Extended Advertising Backscatter with Commodity Devices in Passive IoT Scenarios

Abstract

BLE-based (Bluetooth Low Energy-based) backscatter has received considerable attention, as it aims to communicate with everyday smart devices such as smartphones, smartwatches, and tablets in passive IoT. The state-of-the-art BLE backscatter systems enable communication using a specialized continuous wave (CW) generator or entirely using commodity BLE 4.0 radios as an RF source. However, the existing BLE communication systems suffer from several key issues, including a short carrier length and a large frequency shift. This paper presents a passive BLE (PBLE) backscatter communication system that utilizes commodity BLE 5.0 radios. The system uses a BLE 5.0 extended advertising packet with partial single tones as excitations transmitting on the secondary advertising channel of BLE 5.0, and the BLE backscatter tag produces bandpass frequency-shift keying modulation at 1 Mb/s, which enables compatibility with BLE advertising channels. The prototype is implemented using an NRF52832 BLE 5.0 commodity chip, smart devices, and tags with FPGAS and chips. In FPGA board-level verification, when the downlink distance is 0.5 m, the uplink distance can reach 10 m. In chip testing, the uplink distance can reach 7 m when the downlink distance is 1 m. The baseband power consumption is 2 μW, with a total power consumption of 10 μW. This system eliminates the need for expensive and costly specialized RF sources, unlike the BLE backscatter communication system that uses a specialized CW generator. Compared to the BLE backscatter communication system that uses commodity BLE 4.0 radios, this system reduces the minimum frequency shift from 24 MHz to 2 MHz and increases the length of the single tones as a CW by a factor of about seven, from 31 bytes to 254 bytes.