Characterization and Analysis of Landslide Evolution in Intramountain Areas in Loja (Ecuador) Using RPAS Photogrammetric Products

Abstract

This case study focuses on the area of El Plateado near the city of Loja, Ecuador, where landslides with a high impact on infrastructures require monitoring and control. The main objectives of this work are the characterization of the landslide and the monitoring of its kinematics. Four flights were conducted using a remotely piloted aerial vehicle (RPAS) to capture aerial images that were processed with SfM techniques to generate digital elevation models (DEMs) and orthoimages of high resolution (0.05 m) and sufficient accuracy (below 0.05 m) for subsequent analyses. Thus, the DEM of differences (DoD) and profiles are obtained, but a morphometric analysis is conducted to quantitatively characterize the landslide’s elements and study its evolution. Parameters such as slope, aspect, topographic position index (TPI), terrain roughness index (TRI), and topographic wetness index (TWI) are analyzed. The results show a higher slope and roughness for scarps compared to stable areas and other elements. From TPI, slope break lines have been extracted, which allow the identification of landslide features such as scarps and toe tip. The landslide shows important changes in the landslide body surface, the retraction of the main scarp, and advances of the foot. A general decrease in average slope and TRI and an increase in TWI are also observed due to the landslide evolution and stabilization. The presence of fissures and the infiltration of rainfall water in the unsaturated soil layers, which consist of high-plasticity clays and silts, contribute to the instability. Thus, the study provides insights into the measurement accuracy, identification and characterization of landslide elements, morphometric analysis, landslide evolution, and the relationship with geotechnical factors that contribute to a better understanding of landslides. A higher frequency of the RPAS surveys and quality of geotechnical and meteorological data are required to improve the instability analysis together with a major automation of the GIS procedures.