Design of Current Equalization Circuit in Dual Ethernet Power Supply System-Reference-Cited by-同舟云学术

Design of Current Equalization Circuit in Dual Ethernet Power Supply System

Published:2023-11-18 Issue:4 Volume:13 Page:60
ISSN:2079-9268
Container-title:Journal of Low Power Electronics and Applications
language:en
Short-container-title:JLPEA

Author:

Guan Xingyu¹,Hu Xinyuan¹,Zhang Junkai¹,Jiang Yanfeng¹^ORCID

Affiliation:

1. Department of Electrical Engineering, School of IoT Engineering, Institute of Advanced Technology, Jiangnan University, Wuxi 214122, China

Abstract

A current-balancing circuit for a dual-channel Ethernet power supply system is designed in this paper, which can be used to solve the mismatch between the two channels caused by unavoidable factors, such as mismatched resistances, temperatures and voltages. Based on the design, the mismatch of the currents between the two power transmission paths can be controlled to be less than 1% of the original ones. It can be operated under these conditions with the changes of the load current and the PSE output voltage. The maximum output power of the dual-channel power supply can reach up to 96.5 W. When the DC–DC conversion efficiency is less than 75%, it can still provide 72 W for the PD end, meeting the requirements of the PoE power system. The current-balancing circuit designed in the paper has potential application value to improve the dual PoE power supply system.

Publisher

MDPI AG

Subject

Electrical and Electronic Engineering

Link

https://www.mdpi.com/2079-9268/13/4/60/pdf

Reference32 articles.

1. Li, Y. (2017). Research on High Efficiency Integrated Circuit of Receiving Device Based on IEEE802.3 at Power Supply over Ethernet Standard, Xidian University.

2. Mao, S., and Qiao, D. (2016, January 14–17). Design and lmplementation of An Embedded FTP Server Poweredover Ethernet. Proceedings of the IEEE international Conferene on Computer and Communications (ICCC), Chengdu, China.

3. (2009). IEEE 802.3 at PD with Synchronous No-Opto Flyback Controller and 12V Aux Support, Datasheet (Standard No. LTC4278).

4. (2013). LM5072 Integrated 100V Power over Ethernet PD Interface and PWM Controller with Aux Support, Datasheet Revision 1 (Standard No. LM5072).

5. (2012). 13W/30W IEEE 802.3af/at, PoE Powered Device with Inte-Grated DC-DC Controller, Datasheet Version 1.5 (Standard No. AS1135).