Examination of Glass-Fibre Reinforced Composite Dental Fillings-Reference-Cited by-同舟云学术

Examination of Glass-Fibre Reinforced Composite Dental Fillings

Published:2021-10-01 Issue:2 Volume:4 Page:79-82
ISSN:2601-8799
Container-title:Acta Materialia Transylvanica
language:en
Short-container-title:

Author:

Borhy Levente¹,Farkas Péter Zoltán²,Volom András²

Affiliation:

1. Budapest University of Technology and Economics, Faculty of Mechanical Engineering , Department of Materials Science and Engineering , Budapest , Hungary

2. Dr. Volom Aesthetic Dentistry , Budapest , Hungary

Abstract

Abstract In dentistry, the use of dental fillings is a routine procedure. The use of fillings is a cheap, simple and low-harm dental operation, however, the filling of deep cavities is a difficult task. During this research, three types of fillings were tested: composite fillings bonded directly to the cavity walls, fillings bonded to the cavity walls with a semi-direct method, and composite fillings bonded to the cavity lined with polyethylene fibres. In the course of our examinations, the gaps between the wall of the dental cavity and the dental filling were observed using scanning electron microscopy. The results of these measurements can be used to determine the quality of each type of filling procedure.

Publisher

Acta Materialia Transylvanica

Link

https://www.sciendo.com/pdf/10.33924/amt-2021-02-04

Reference17 articles.

1. [1] GBD 2017 Disease and Injury Incidence and Prevalence Collaborators.: Global, regional, and national incidence, prevalence, and years lived with disability for 354 diseases and injuries for 195 countries and territories, 1990–2017: a systematic analysis for the Global Burden of Disease Study 2017, The Lancet, 392. (2018) 1789–1858. https://doi.org/10.1016/S0140-6736(18)32279-710.1016/S0140-6736(18)32279-7

2. [2] Nanci A.: Chapter 8. Dentin-Pulp Complex. In: Ten Cate’s Oral Histology (8. Ed.). Mosby, 2013. 165–204. https://doi.org/10.1016/B978-0-323-07846-7.00008-210.1016/B978-0-323-07846-7.00008-2

3. [3] Urabe I., Nakajima S., Sano H., Tagami J.: Physical properties of the dentin-enamel junction region. American Journal of Dentistry, 13. (2000) 129–135.

4. [4] ISO 18458: Biomimetics − Terminology, concepts and methodology, 2015.

5. [5] Bazos P., Magne P.: Bio-emulation: biomimetically emulating nature utilizing a histoanatomic approach; structural analysis. The European Journal of Esthetic Dentistry, 6. (2011) 8–19.