Design and Manufacture of a Micro Unmanned Aerial Vehicle-Reference-Cited by-同舟云学术

Design and Manufacture of a Micro Unmanned Aerial Vehicle

Published:2024-01 Issue:1 Volume:37 Page:
ISSN:0893-1321
Container-title:Journal of Aerospace Engineering
language:en
Short-container-title:J. Aerosp. Eng.

Author:

Dominguez Victor H.¹,Reyes-Osorio Luis A.²^ORCID,Ollervides-Vazquez Javier³,Garcia-Salazar Octavio⁴^ORCID

Affiliation:

1. Student Research Fellow, Aerospace Engineering Research and Innovation Center, Faculty of Mechanical and Electrical Engineering, Autonomous Univ. of Nuevo Leon, Apodaca, Nuevo Leon 66616, Mexico.

2. Professor and Researcher, Aerospace Engineering Research and Innovation Center, Faculty of Mechanical and Electrical Engineering, Autonomous Univ. of Nuevo Leon, Apodaca, Nuevo Leon 66616, Mexico. ORCID: .

3. Professor and Researcher, Division of Graduate Studies and Research, Technological Institute of La Laguna-TecNM, Torreon, Coahuila 27000, Mexico; Aerospace Engineering Research and Innovation Center, Faculty of Mechanical and Electrical Engineering, Autonomous Univ. of Nuevo Leon, Apodaca, Nuevo Leon 66616, Mexico.

4. Professor and Researcher, Aerospace Engineering Research and Innovation Center, Faculty of Mechanical and Electrical Engineering, Autonomous Univ. of Nuevo Leon, Apodaca, Nuevo Leon 66616, Mexico (corresponding author). ORCID: .

Publisher

American Society of Civil Engineers (ASCE)

Subject

Mechanical Engineering,Aerospace Engineering,General Materials Science,Civil and Structural Engineering

Link

https://ascelibrary.org/doi/pdf/10.1061/JAEEEZ.ASENG-4912

Reference20 articles.

1. Optimization of fused deposition modeling parameters for improved PLA and ABS 3D printed structures;Abeykoon C.;Int. J. Lightweight Mater. Manuf.,2020

2. A REVIEW OF MECHANICAL AND THERMAL PROPERTIES OF PRODUCTS PRINTED WITH RECYCLED FILAMENTS FOR USE IN 3D PRINTERS

3. Tensile, three-point bending and impact strength of 3D printed parts using PLA and recycled PLA filaments: A statistical investigation

4. Behzadnasab M. and A. A. Yousefi. 2016. “Effects of 3D printer nozzle head temperature on the physical and mechanical properties of PLA based product.” In Proc. 12th Int. Seminar on Polymer Science and Technology 2–5. Tehran Iran: Iranian Society of Toolmakers.

5. Cabriales-Ramírez L. E. V. H. Dominguez M. A. Gutierrez-Martinez E. Javier Ollervides-Vazquez E. G. Rojo-Rodriguez P. A. Tellez-Belkotosky and O. Garcia-Salazar. 2021. “Trajectory tracking based on a saturated PD controller on SE (3) for a micro coaxial drone.” In Proc. 2021 Int. Conf. on Mechatronics Electronics and Automotive Engineering (ICMEAE) 146–153. New York: IEEE.