Cup safe zone and optimal stem anteversion in total hip arthroplasty for patients with highly required range of motion

Abstract

AbstractTo avoid dislocation after total hip arthroplasty, it is desirable to avoid implant impingement during activities of daily living. Numerous simulation studies have been performed at 30° of internal rotation (IR) with 90° of flexion. However, these studies may not reflect the impingement that occurs during activities such as floor sitting, which require a larger IR during flexion. The purpose of this study was to assess the impact of varying IR angles during flexion on the impingement‐free safe zone and optimal stem anteversion. In this study, implant impingement simulation was evaluated in computer simulation. The prosthesis used a flat liner, and a 32‐ or 40‐mm femoral head and stem. Three patterns of required IR angle (30° IR/40° IR/50° IR with 90° flexion) combined with 13 directions of the required range of motion were simulated. The optimal stem anteversion to maximize the safe zone was analyzed. Increasing the required IR at 90° flexion decreased the safe zone, particularly with small stem anteversion angles. With a 32‐mm head, the desirable stem anteversion at 40° of cup inclination was 15°/25°/35° in required 30° IR/40° IR/50° IR with 90° flexion, respectively. The safe zone area of the 32‐mm head was smaller than that of the 40‐mm head. For patients who require a larger IR with 90° flexion, the stem and cup target anteversion should be adjusted according to the implant design, head diameter, and patient's required IR at flexion in their lifestyle.