Investigating the effect of printing conditions and annealing on the porosity and tensile behavior of <scp>3D</scp> ‐printed polyetherimide material in <scp>Z</scp> ‐direction-Reference-Cited by-同舟云学术

Investigating the effect of printing conditions and annealing on the porosity and tensile behavior of 3D ‐printed polyetherimide material in Z ‐direction

Published:2022-11-11 Issue:4 Volume:140 Page:
ISSN:0021-8995
Container-title:Journal of Applied Polymer Science
language:en
Short-container-title:J of Applied Polymer Sci

Author:

Ouassil Salah‐Eddine¹,El Magri Anouar¹^ORCID,Vanaei Hamid Reza²³^ORCID,Vaudreuil Sébastien¹

Affiliation:

1. Euromed Polytechnic School, Euromed Research Center Euromed University of Fes Fes Morocco

2. Léonard de Vinci Pôle Universitaire, Research Center 92916 Paris La Défense France

3. Arts et Métiers Institute of Technology CNAM, LIFSE, HESAM University Paris France

Funder

EUROMED UNIVERSITY OF FES

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,Surfaces, Coatings and Films,General Chemistry

Link

https://onlinelibrary.wiley.com/doi/pdf/10.1002/app.53353

Reference49 articles.

1. Investigating Effects of Fused-Deposition Modeling (FDM) Processing Parameters on Flexural Properties of ULTEM 9085 using Designed Experiment

2. Influence of 3D Printing FDM Process Parameters on Tensile Property of ULTEM 9085

3. Experimental investigation and optimization of printing parameters of 3D printed polyphenylene sulfide through response surface methodology

4. Mechanical properties analysis of polyetherimide parts fabricated by fused deposition modeling

5. Effects of printing parameters on the tensile behavior of 3D ‐printed acrylonitrile styrene acrylate ( ASA ) material in Z direction

Cited by 27 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. OPTIMIZATION OF ANNEALING AND 3D PRINTING PROCESS PARAMETERS OF PLA PARTS;International Journal of 3D Printing Technologies and Digital Industry;2024-08-30

2. Investigating the tensile properties and crystallinity of 3D-printed poly (ether ether ketone)/poly (ether imide) [PEEK/PEI] blend in the Z-direction by fused filament fabrication;Progress in Additive Manufacturing;2024-08-29

3. Critical quality indicators of high-performance polyetherimide (ULTEM) over the MEX 3D printing key generic control parameters: Prospects for personalized equipment in the defense industry;Defence Technology;2024-08

4. Large strain mechanical behaviors of optically clear adhesives for flexible electronic devices under different temperature, humidity, and strain rates;Journal of Applied Polymer Science;2024-06-11

5. Effect of in situ thermal treatment on interlayer adhesion of 3D printed polyetherimide (PEI) parts produced by fused deposition modeling (FDM);Materials Today Communications;2024-06