Experimental Investigation of the Effects of Process Conditions on the Morphology in Injection Molding of Polymer Blends-Reference-Cited by-同舟云学术

Experimental Investigation of the Effects of Process Conditions on the Morphology in Injection Molding of Polymer Blends

Published:2015-10-16 Issue:3 Volume:36 Page:341-351
ISSN:0730-6679
Container-title:Advances in Polymer Technology
language:en
Short-container-title:Adv Polym Technol

Author:

Liu Fen¹²,Zhang Yi¹,Zhang Yun¹,Huang Zhigao¹,Ying Jiru³,Xie Xiaolin⁴,Zhou Huamin¹

Affiliation:

1. State Key Laboratory of Material Processing and Die & Mold Technology; Huazhong University of Science and Technology; Wuhan 430074 People's Republic of China

2. Department of Mechanical and Biomedical Engineering; City University of Hong Kong; Kowloon, Hong Kong People's Republic of China

3. Hubei Provincial Key Laboratory of Green Materials for Light Industry; Hubei University of Technology; Wuhan 430068 People's Republic of China

4. School of Chemistry and Chemical Engineering; Huazhong University of Science and Technology; Wuhan 430074 People's Republic of China

Publisher

Wiley

Subject

Polymers and Plastics,Organic Chemistry,General Chemical Engineering

Reference24 articles.

1. Interrelationships of morphology, thermal and mechanical properties in uncrosslinked and dynamically crosslinked PP/EOC and PP/EPDM blends

2. Modeling of morphology evolution in the injection molding process of thermoplastic polymers

3. Moulding anisotropy in ABS polymers as revealed by electron microscopy

4. Skin-Core morphology and failure of injection-molded specimens of impact-modified polypropylene blends

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Development of Unstable Flow and Morphological Analysis of Flow Marks in Injection Molding of Polypropylene and Polyolefin Elastomer Blend;Industrial & Engineering Chemistry Research;2023-08-18

2. Realizing simultaneous high‐temperature strength and low‐temperature elongation in polyolefin elastomer toughened polypropylene via controlling the dispersed phase size;Journal of Applied Polymer Science;2022-12-20

3. Effect on the Impact Properties of Adding Long‐Chain Branched Polypropylene in Polypropylene‐Polyolefin Elastomer Cellular Polymers Produced by Core‐Back Injection Molding;Macromolecular Materials and Engineering;2021-02-26

4. Effect of the elastomer viscosity on the morphology and impact behavior of injection molded foams based on blends of polypropylene and polyolefin elastomers;Journal of Applied Polymer Science;2020-12-28

5. Five-Axis Tool Path Generation of Injection Mold Represented by T-Spline Surface;Advances in Polymer Technology;2020-03-09