Effect of externally applied magnetic field on the tool wear and surface morphology of Inconel 718 in turning operation-Reference-Cited by-同舟云学术

Effect of externally applied magnetic field on the tool wear and surface morphology of Inconel 718 in turning operation

Published:2023-07-10 Issue:1 Volume:6 Page:
ISSN:2577-8196
Container-title:Engineering Reports
language:en
Short-container-title:Engineering Reports

Author:

Waghmode Sukhdev B.¹^ORCID,Kallol Anupama N.¹,Shivakumar S.¹^ORCID,Manjunath G. A.¹^ORCID,Doiphode Rajendra L.²,Chandrashekar A.³,Omprakash B.⁴,Razak Abdul⁵^ORCID,Hasan Nasim⁶

Affiliation:

1. Department of Mechanical Engineering K. L. S. Gogte Institute of Technology Belagavi India

2. Department of Mechanical Engineering Government Polytechnic Kolhapur India

3. Department of Mechanical Engineering Bangalore Institute of Technology Bengaluru India

4. Department of Mechanical Engineering JNTUA College of Ananthapuram Anantapur India

5. Department of Mechanical Engineering, P. A. College of Engineering Affiliated to Visvesvaraya Technological University Belagavi India

6. Mechanical Engineering Department Mattu University Mettu Oromia Ethiopia

Abstract

AbstractThis study examined the effect of magnetic field with single point coated‐carbide tool during turning process of Inconel718 (In718). After the turning process, tribological properties (surface roughness and tool wear) and chip morphology were analyzed. Two cylindrical Neodymium (N52) grade permanent magnets are used to apply the magnetic field during the machining. Cutting speed and magnetic field intensity along with constant feed and depth of cut are used to analyze tribological properties along with chip morphology. Experimental results show that 80 m/min cutting speed and 426 Gauss magnetic field has the best results in term of lowest surface roughness and tool wear. Lorentz forces developed due to the applied external magnetic field help to improve surface roughness compared to nonmagnetic field machining. Developed fine particles during the turning process get repulsed in case of magnetic field machining which helps to improve tool wear.

Publisher

Wiley

Subject

General Engineering,General Computer Science

Link

https://onlinelibrary.wiley.com/doi/pdf/10.1002/eng2.12700

Reference29 articles.

1. Machinability improvement of Inconel 718 through mechanochemical and heat transfer effects of coated surface-active thermal conductive mediums

2. Investigation on residual stress evolution in nickel-based alloy affected by multiple cutting operations

3. Comparison the machinability of Inconel 718, Inconel 625 and Monel 400 in hot turning operation

4. Tool wear reduction in machining Inconel 718 by using novel sustainable cryo-lubrication techniques

5. Influences of coating thickness on cutting temperature for dry hard turning Inconel 718 with PVD TiAlN coated carbide tools in initial tool wear stage