Effect of electromagnetic force installation method on critically reinforced interference sizes and fatigue behavior of CFRP bolted joints

Abstract

AbstractThe electromagnetic force dynamic installation (DI) method of interference fit fasteners has significant advantages in improving the quality of the assembly interface of composite structure. This study aims to investigate how improving assembly interface quality may help in achieving high‐precision interference‐fit joints in composites. Single‐lap joint specimens were prepared using electromagnetic installation technique, the fatigue life and failure behaviors of the joints under different bolt‐hole clearances were measured and analyzed experimentally. In addition, a three‐dimensional finite element model was developed to predict the radial pre‐compression stresses around the hole and the progressive failure behavior of various typical damage modes in carbon fiber‐reinforced polymer induced by the interference. The results show that the critical interference range for the DI‐composite bolted structure is 1.0%–1.2%. The fatigue life of the best interference (1.0%) and the worst interference (0%, neat fit) have a difference of 36 times in amplitude. The residual stress with uniform distribution and high amplitude reduces the stress concentration of the hole wall and improves the failure evolution of the loaded hole. The contribution of this study provides vital guidance for improving the fatigue performance of CFRP bolted structures using a novel DI method.Highlights I = 1.0% is the critical damage‐enhancing interference size for dynamically installation interference fit bolts with electromagnetic forces. The residual stress amplitude introduced by the interference does not increase uniformly as the interference size increases. Excessive interference significantly reduces the uniformity and magnitude of residual stresses. Under subsequent cyclic loading, the fifth layer near the inlet and outlet of the extruded lower laminate appears to be the critical ply of extrusion deformation, and severe damage is concentrated in the critical ply of deformation. The decrease of stress amplitude and the variation of mean stress are the mechanisms of fatigue life enhancement in interference fit joints under external cyclic loading.