Optimization and numerical simulation analysis for molded thin-walled parts fabricated using wood-filled polypropylene composites via plastic injection molding-Reference-Cited by-同舟云学术

Optimization and numerical simulation analysis for molded thin-walled parts fabricated using wood-filled polypropylene composites via plastic injection molding

Published:2014-07-10 Issue:5 Volume:55 Page:1082-1095
ISSN:0032-3888
Container-title:Polymer Engineering & Science
language:en
Short-container-title:Polym Eng Sci

Author:

Azaman M.D.¹²,Sapuan S.M.¹³,Sulaiman S.¹,Zainudin E.S.¹³⁴,Khalina A.⁵⁶

Affiliation:

1. Department of Mechanical and Manufacturing Engineering; Universiti Putra Malaysia; 43400 UPM Serdang Selangor Malaysia

2. School of Manufacturing Engineering, Universiti Malaysia Perlis; 02600 Arau Perlis Malaysia

3. Laboratory of Biocomposite Technology, Institute of Tropical Forestry and Forest Products (INTROP), Universiti Putra Malaysia; 43400 UPM Serdang Selangor Malaysia

4. School of Engineering and Design, Brunel University, Uxbridge Middlesex; UB8 3PH UK

5. Department of Biological and Agricultural Engineering; Universiti Putra Malaysia; 43400 UPM Serdang Selangor Malaysia

6. Aerospace Malaysia Innovation Centre, Universiti Putra Malaysia; 43400 UPM Serdang Selangor Malaysia

Funder

UNIVERSITI PUTRA MALAYSIA

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,General Chemistry,Materials Chemistry,Polymers and Plastics,General Chemistry

Reference31 articles.

1. An analysis of thermal warpage in injection molded flat parts due to unbalanced cooling

2. Research on the reduction of sink mark and warpage of the molded part in rapid heat cycle molding process

3. An investigation of the processability of natural fibre reinforced polymer composites on shallow and flat thin-walled parts by injection moulding process

4. Microinjection molding of thermoplastic polymers: a review

Cited by 20 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. In-situ melt flowability detection and product quality evaluation in injection molding: A simplified approach;Measurement;2024-10

2. Measurement techniques in injection molding: A comprehensive review of machine status detection, molten resin flow state characterization, and component quality adjustment;Measurement;2024-02

3. A holistic failure modes and effects analysis for university plastic injection laboratory under Bayesian Network;Applied Soft Computing;2023-11

4. Optimization of the Reduction of Shrinkage and Warpage for Plastic Parts in the Injection Molding Process by Extended Adaptive Weighted Summation Method;Polymers;2022-11-25

5. Recent progress in minimizing the warpage and shrinkage deformations by the optimization of process parameters in plastic injection molding: a review;The International Journal of Advanced Manufacturing Technology;2022-02-10