Mold-filling studies for the injection molding of thermoplastic materials. Part I: The flow of plastic materials in hot- and cold-walled circular channels-Reference-Cited by-同舟云学术

Mold-filling studies for the injection molding of thermoplastic materials. Part I: The flow of plastic materials in hot- and cold-walled circular channels

Published:1975-08 Issue:8 Volume:15 Page:553-568
ISSN:0032-3888
Container-title:Polymer Engineering and Science
language:en
Short-container-title:Polym. Eng. Sci.

Author:

Williams G.,Lord H. A.

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,General Chemistry,Materials Chemistry,Polymers and Plastics,General Chemistry

Reference26 articles.

1. Mold-filling studies for the injection molding of thermoplastic materials. Part II: The transient flow of plastic materials in the cavities of injection-molding dies

2. Heat effects in capillary flow I

3. Nonisothermal Flow of Viscous Non-Newtonian Fluids

4. Heat transfer in forced convection with internal heat generation

Cited by 95 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Approaches for Numerical Modeling and Simulation of the Filling Phase in Injection Molding: A Review;Polymers;2023-10-25

2. Evaluation of the Predictive Capacity of Viscosity Models in Polymer Melt Filling Simulations;Journal of Materials Engineering and Performance;2022-08-17

3. Intelligent setting of process parameters for injection molding based on case-based reasoning of molding features;Journal of Intelligent Manufacturing;2020-08-28

4. Formation mechanism of hierarchically crystalline structures under coupled external fields in multi-melt multi-injection molding: Simulation and experiment;Composites Part B: Engineering;2020-05

5. Polymer Processing;Mechanical Engineering Series;2018