Lateral‐torsional buckling experiments of built‐up section CFS beams

Abstract

AbstractThis paper investigates the lateral‐torsional buckling of built‐up cold‐formed steel beams featuring two or three component C‐ or sigma‐sections arranged to have a closed loop. Several thicknesses of each cross‐section with nominal yield stress values of 450 MPa and 550 MPa were tested to obtain lateral buckling strength data for a range of cross‐section slenderness values. Complementary reference tests were conducted on the same built‐up sections braced laterally to obtain the in‐plane section capacities, precluding the effect of lateral‐torsional buckling. Coupon tests were also conducted to determine the mechanical properties of the steel material. The test rig featured a dual‐actuator set‐up, with one actuator (applying vertical load) mounted on a trolley that was moved horizontally by the second actuator in response to the signal from a transducer measuring the lateral buckling displacement at the mid‐length of the beam, thus ensuring vertical loading throughout the experiments. The rig also featured specialized end bearings allowing free flexural rotations and warping, while restraining lateral displacements and twist rotations. The paper describes the test rig and the results of the in‐plane and lateral‐torsional buckling experiments. Particular attention is paid to the use of closed parts to enhance the torsional rigidity of the built‐up sections and thereby their lateral‐torsional buckling capacity.