Coupling of electrodialysis and bio‐electrochemical systems for metal and energy recovery from acid mine drainage

Abstract

AbstractBACKGROUNDThis work studied the treatment of a synthetic sphalerite acid mine drainage (AMD). The treatment was carried out by means of a previous concentration stage using electrodialysis, followed by electrodeposition using a bioelectrochemical system (BES).RESULTSThe best concentration results were obtained when operating the electrodialysis at 8 V and at a diluate/concentrate volume ratio of 3. This treatment yielded a concentrate fraction of about 25% of the volume and a clear fraction of about 75% of the volume.The concentrated fraction was treated in a BES for the electrodeposition of the metal contained. By operating a microbial fuel cell (MFC), the spontaneous reactions took place and, in 2 days, all the Fe3+ was reduced to Fe2+; then, all the Cu2+ was electrodeposited as pure Cu0 in about 8 days. The maximum current density attained in this stage was 0.1 mA cm−2 and the maximum power was 0.05 W cm−2. Then, a subsequent operation of a microbial electrolysis cell (MEC) allowed for the simultaneous recovery of the Fe2+, Ni2+, Zn2+, and Cd2+ as a mixed metal mass.CONCLUSIONThe electrodialysis yielded a clear effluent representing 75% of the total volume and a concentrated effluent accounting for 25%. It was possible to treat the concentrated effluent in an MFC, recovering pure Cu0 with a net electricity generation. The non‐spontaneous metal reductions were subsequently accomplished by means of MEC, the electricity requirements being lower than those in the case of the raw AMD due to the higher mass transfer rate and the reduction of the Ohmic loses. © 2023 Society of Chemical Industry (SCI).