Experimental study on clogging of three different types of emitters with similar properties

Abstract

AbstractThe drip irrigation process has been designed to reduce water losses, and to combine irrigation, with the supply of fertilizers. However, in drip irrigation systems, the clogging of emitters is a major problem that significantly reduces the performance of drip irrigation systems. The water used in these systems is generally loaded with suspended matter, which might cause clogging of the emitters. This work was carried out in order to evaluate the clogging rate in three different types of emitters with roughly similar flow rates, tested in an experimental drip irrigation system, using water pumped from the Sebou River. Thus, a compensating‐pressure emitter named E1 and two non‐compensating‐pressure emitters named E2 and E3 were tested. Each dripper was subjected to 112 irrigations, which lasted 397 h and were spread over a period of 2 months. To evaluate the hydraulic performance of the emitters, the following three coefficients were used to measure the effect of clogging: (i) the variation of the flow ratio (Dra), which reflects the degree of clogging; (ii) the emission uniformity coefficient (EU); and (iii) the Christiansen uniformity coefficient (CU). No emitters became completely clogged during the experiment. However, as the clogging rate increased, the average flow rates measured in some emitters at the end of the test had decreased by 89% compared to the initial flow rates. During the experiment, flow fluctuations were observed during the evolution of the clogging, which could come from a partial recovery of flow.