Affiliation:
1. National Renewable Energy Laboratory Golden CO 80401 USA
Abstract
AbstractSe alloying has enabled significantly higher carrier lifetimes and photocurrents in CdTe solar cells, but these benefits can be highly dependent on CdSexTe1‐x processing. This work evaluates the optoelectronic, chemical, and electronic properties of thick (3 µm) undoped CdSexTe1‐x of uniform composition and varied processing conditions (CdSexTe1‐x evaporation rate, CdCl2 anneal, Se content) chosen to reflect various standard device processing conditions. Sub‐bandgap defect emission is observed, which increased as Se content increased and with “GrV‐optimized CdCl2” (i.e., CdCl2 anneal conditions used for group‐V‐doped devices). Low carrier lifetime is found for GrV‐optimized CdCl2, slow CdSexTe1‐x deposition, and low‐Se films. Interestingly, all films (including CdTe control) exhibited n‐type behavior, where electron density increased with Se up to an estimated ≈1017 cm−3. This behavior appears to originate during the CdCl2 anneal, possibly from Se diffusion leading to anion vacancy (e.g., VSe, VTe) and ClTe generation.
Funder
National Renewable Energy Laboratory
Reference74 articles.
1. EIA. Construction cost data for electric generators installed in 2020. EIA https://www.eia.gov/electricity/generatorcosts/(accessed: May2023).
2. Embodied energy and carbon from the manufacture of cadmium telluride and silicon photovoltaics
3. Arsenic-Doped CdSeTe Solar Cells Achieve World Record 22.3% Efficiency
4. N. R. E. Laboratory Best Research‐Cell Efficiency Chart.https://www.nrel.gov/pv/cell‐efficiency.html(accessed: March 2024).