The modified Nice knot has improved mechanical performance compared to the cinch stitch for meniscal root repair

Abstract

AbstractPurposeAccording to previous biomechanical studies, the success of meniscus root repair depends on the suture–meniscus interface and optimisation of this procedure seems to be critical. A progressive, reliable and adjustable knot has numerous advantages in meniscal repair since the surgeon can adapt and meticulously tune the final strength of the fixation. We hypothesised that a single passage of one tape at two different points of the posterior meniscal root with a modified Nice knot configuration may allow similar or superior fixation for root repair compared to the cinch stitch suture technique.MethodsPosterior root repair of medial and lateral meniscus was performed on 26 porcine knees. In group (A), two simple cinch stitches were applied, and in group (B), a modified Nice knot was used in a crossmatch configuration. For both groups, two passages through the meniscus with a 2‐mm braided tape were used, and a single transosseous tibial tunnel technique was performed and tested in pull‐out conditions.ResultsThe modified Nice knot showed an improved biomechanical performance considering the maximum failure load for both the medial (600.7 ± 77.5 N) and lateral (686.1 ± 83.5 N) (p = 0.006) posterior root fixation when compared to a double cinch stitch (558.0 ± 123.9 N) and (629.0 ± 110.2 N) (p = 0.178) for medial and lateral fixation, respectively. The maximum stiffness was also higher for the modified Nice knot configuration for both medial (17.1 ± 1.5 vs. 13.3 ± 1.6 N/mm) and lateral meniscus (20.0 ± 2.6 vs. 13.8 ± 2.3 N/mm), being this difference statistically significative (p = 0.001).ConclusionsThe modified Nice knot allowed better adaptation in the pull‐out tests and presented higher fixation strength, stiffness and reproducibility, with lower standard deviation, being at the same time economically advantageous, since only one tape is needed.Level of EvidenceLevel III.