Numerical simulation on residual thickness of pipes with curved sections in water-assisted co-injection molding-Reference-Cited by-同舟云学术

Numerical simulation on residual thickness of pipes with curved sections in water-assisted co-injection molding

Published:2015-05-27 Issue:34 Volume:132 Page:n/a-n/a
ISSN:0021-8995
Container-title:Journal of Applied Polymer Science
language:en
Short-container-title:J. Appl. Polym. Sci.

Author:

Kuang Tang-Qing¹,Xu Bai-Ping²,Zhou Guo-Fa³,Turng Lih-Sheng⁴

Affiliation:

1. School of Mechanical & Electrical Engineering; East China Jiaotong University; Nanchang 330013 China

2. Technology Development Center for Polymer Processing Engineering of Guangdong Colleges and Universities, Guangdong Industry Technical College; Guangzhou 510641 China

3. School of Environmental and Chemical Engineering, Nanchang University; Nanchang 330000 China

4. Polymer Engineering Center and Wisconsin Institute for Discovery; University of Wisconsin-Madison; Madison 53706 Wisconsin

Funder

National Natural Science Foundation of China

China Scholarship Council

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,Surfaces, Coatings and Films,General Chemistry

Reference30 articles.

1. Two-component water assisted injection moulding

2. Water-assisted injection molding of thermoplastic materials: Effects of processing parameters

Cited by 11 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental and numerical investigations on formation mechanisms of hollow structures in overflow water‐assisted injection‐molded parts of short‐glass‐fiber‐reinforced polypropylene;Journal of Applied Polymer Science;2024-06-24

2. Numerical and experimental investigations on the mechanism of flow‐induced fiber orientation in short‐shot water‐assisted injection‐molded short‐glass‐fiber‐reinforced polypropylene;Journal of Applied Polymer Science;2022-03-26

3. Formation mechanism of high‐pressure water penetration induced fiber orientation in overflow water‐assisted injection molded short glass fiber‐reinforced polypropylene;Journal of Applied Polymer Science;2021-05-22

4. Fluid-Powered Projectile-Assisted Injection Molding: Principles and Developments;International Polymer Processing;2020-03-06

5. Effect of Process Parameters on Short Fiber Orientation along the Melt Flow Direction in Water-Assisted Injection Molded Part;Advances in Materials Science and Engineering;2019-08-19