The influence of the type of polypropylene and the length of the flow path on the structure and properties of injection molded parts with the weld lines-Reference-Cited by-同舟云学术

The influence of the type of polypropylene and the length of the flow path on the structure and properties of injection molded parts with the weld lines

Published:2019-06-24 Issue:8 Volume:59 Page:1710-1718
ISSN:0032-3888
Container-title:Polymer Engineering & Science
language:en
Short-container-title:Polym Eng Sci

Author:

Bociąga Elżbieta¹^ORCID,Kaptacz Sławomir¹^ORCID,Duda Piotr¹,Rudawska Anna²

Affiliation:

1. Faculty of Computer Science and Materials ScienceUniversity of Silesia in Katowice ul. Żytnia 12, Sosnowiec 41‐200 Poland

2. Faculty of Mechanical EngineeringLublin University of Technology ul. Nadbystrzycka 36, Lublin 20‐618 Poland

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,General Chemistry,Materials Chemistry,Polymers and Plastics,General Chemistry

Link

https://onlinelibrary.wiley.com/doi/pdf/10.1002/pen.25170

Reference37 articles.

1. Fracture Behavior of Weld Lines in Injection Molded Components Loaded under Real Operating Conditions

2. Designing with Plastics

3. Total Quality Process Control for Injection Molding

4. Weld line formation in the parts from multicavity injection mold

Cited by 17 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Visualization and monitoring of the injection molding process using ultrasonic phased array;Journal of Materials Processing Technology;2024-05

2. One Factor at a Time Investigation of Injection Molding Process for Thin-Walled Laptop Component via Simulation;Lecture Notes in Mechanical Engineering;2024

3. Weld‐lines and its strength evaluation in injection molded parts: A review;Polymer Engineering & Science;2023-08-31

4. Analysis of the Influence of the Mould Temperature in the Weld Line Areas on Strength of the Injection Mouldings;Archives of Metallurgy and Materials;2023-07-26

5. Influence of injection molding parameters, melt flow rate, and reinforcing material on the weld‐line characteristics of polypropylene;Polymer Engineering & Science;2023-03-27