CHARACTERIZATION OF THE LOAD‐SLIP BEHAVIOUR OF HEADED STUD SHEAR CONNECTIONS IN NARROW PROFILED SHEETING-Reference-Cited by-同舟云学术

CHARACTERIZATION OF THE LOAD‐SLIP BEHAVIOUR OF HEADED STUD SHEAR CONNECTIONS IN NARROW PROFILED SHEETING

Published:2023-02 Issue:1 Volume:6 Page:242-254
ISSN:2509-7075
Container-title:ce/papers
language:en
Short-container-title:ce papers

Author:

Vigneri V.¹,Odenbreit C.¹,Schäfer M.¹,Hicks S.²,Lam D.³,Hanus F.⁴

Affiliation:

1. University of Luxembourg, Faculty of Science, Technology and Medicine, Department of Engineering

2. University of Warwick, School of Engineering

3. University of Bradford, Faculty of Engineering and Informatics, Department of Civil and Structural Engineering

4. Steligence Engineering, ArcelorMittal

Abstract

AbstractAlthough headed stud shear connections in profiled sheeting represent an efficient solution to transfer the longitudinal shear along composite beams, current EN 1994‐1‐1 may overestimate their design resistance in case of open trough profile steel sheeting with narrow ribs. Project team CEN/TC250/SC4.T3 proposed new equations based on a “cantilever” model which depends on the concrete tensile strength and the bending resistance of the connector. However, by increasing the slips, the internal forces redistribute, and the system can be represented by a “modified strut and tie” model. At large displacements, a “strut and tie” model was also developed accounting for the influence of the tensile forces in the connector. The respective analytical equations for predicting the load per stud were finally derived and compared with experimental load‐slip curves. It was found that the analytical models proposed lead to satisfactory predictions of the load‐slip behaviour of the shear connection.

Publisher

Wiley

Subject

General Earth and Planetary Sciences,General Environmental Science

Link

https://onlinelibrary.wiley.com/doi/pdf/10.1002/cepa.1908

Reference20 articles.

1. British Standards Institution “EN 1994-1-1:2004 Eurocode 4 - Design of composite steel and concrete structures Part 1-1: General rules and rules for buildings ” London 2004.

2. K.RoikandG.Hanswille “Tragfähigkeit von Kopfbolzendübeln Hintergrundbericht zu Eurocode 4. ” Bericht EC4/12/89 1989.

3. H.BodeandR.Künzel “Zur Verwendung von Profilblechen beim Trägerverbund ”Der Metallbau im Konstruktiven Ingenieurbau vol. Festschrift Rolf Baehre 1990.

4. RESISTANCE TO LONGITUDINAL SHEAR OF COMPOSITE BEAMS WITH PROFILED SHEETING.

5. G.Hanswille C.KajzarandA.Faßbender “Ergänzende Regelungen für die Tragfähigkeit von Kopfbolzendübeln bei Verwendung von vorgelochten Profilblechen ” Forschungsbericht 93-01 Wuppertal 1993.