Optimal management strength of cutting parts of tools from STM when there is turning heatresistant alloys on CNC machines-Reference-Cited by-同舟云学术

Optimal management strength of cutting parts of tools from STM when there is turning heatresistant alloys on CNC machines

Published:2019-11-17 Issue:5 Volume: Page:132-139
ISSN:0445-0108
Container-title:Oil and Gas Studies
language:
Short-container-title:Izvestiâ vysših učebnyh zavedenij. Neftʹ i gaz

Author:

Belozerov V. A.¹,Barbyshev В. V.¹

Affiliation:

1. Industrial University of Tyumen

Abstract

The article considers the developed and implemented in the cutting process methodology for managing the dynamic strength of the cutting parts with the tops of tools from STM simultaneously on the front and back surfaces of these tools at thin turning of heatresistant alloys on CNC machines. The specified methodology is based on optimizing (physical, thermal) models of process of thin turning of heatresistant alloys tools from STM developed by us and the offered concept of passing of process of interaction of the processed and tool materials in the conditions of optimization of contact voltage and temperatures at the same time on the front and back surfaces of the tool from STM when cutting.

Publisher

Industrial University of Tyumen

Subject

General Medicine

Reference18 articles.

1. Belozerov, V. A. (2015). The optimization model of the process of fine turning of heat-resistant alloys by tools made from STM. Oil and Gas Studies, (5), 90-95. (In Russian). DOI: 10.31660/0445-0108-2015-5-90-95

2. Starkov, V. K. (2009). Physics and optimization of cutting of materials. Moscow, Mashinostroenie Publ., 639 p. (In Russian).

3. Gruby, S. V. (2008). Metody optimizatsii rezhimnykh parametrov lezviynoy obrabotki. Moscow, Bauman University Publ., 96 p. (In Russian).

4. Artamonov, E. V., Vasil’ev, D. V., Kireev, V. V., & Uteshev, M. H. (2017). Mechanics of chip formation in cutting. Russian Engineering Research, (37), pp. 450-454. (In English). DOI: 10.3103/S1068798X17050069

5. Putilova, Yu. S., Starikov, A. I., & Kharitonov, D. A. (1991). Definition of deformation of the cut-off layer and rational loading of the cutting tool when turning on CNC machines. Russian Engineering Research, 34(12), pp. 826-828. (In English).