Study on Simulation of Stamping Process and Optimization of Process Parameters of Fender

Abstract

In order to obtain the optimum technological parameters of fender forming, the finite element analysis software DYNAFORM is used to simulate the drawing process of fender in this paper. The orthogonal test is designed and completed. On the basis of the orthogonal test, Taguchi method is used to design the orthogonal inner table, and the SNR of each factor at each level is calculated. The results of Taguchi method are analyzed with variance analysis, and the adjustable influencing variables and influence factors on quality stability that affect the forming quality of the fender are obtained. Experimental optimization of the adjustable variables is carried out again to obtain the optimal combination of process parameters that affect the shaping quality of the fender. The optimal combination of process parameters is as follows: blank holder force is 120 kN, model clearance is 1.0 t (t represents sheet thickness), friction coefficient is 0.11, and radius of die is 6 mm. Finally, the experimental results show that the fender manufactured with this combination of process parameters has better performance.