The Study of Continuous Core Zoning to Extend the Graphite Component Irradiation Lifespan in Molten Salt Reactor

Abstract

Graphite is widely used in molten salt reactors (MSRs) because of its excellent properties. However, the irradiation lifespan of graphite in MSR is much shorter than the life of a conventional nuclear power plant, which lowers the load factor and increases the economic burden. In this paper, to extend the graphite irradiation lifespan, one uniform radial fast neutron field was designed by changing the fuel distribution in different radial fuel channels, which is called continuous core zoning. A positive correlation correction algorithm was used to adjust the fuel volumetric fraction (VF) of each zone. The optimization was carried out among different reactor sizes and different thicknesses of the reflector to study flattening characteristics. After optimization, the difference in fast neutron flux between different zones of the flattened region was less than 1%. Compared to the unoptimized case, the peak value of the fast neutron flux can be most reduced by 48.6%. The study employed a single‐channel heat transfer model to investigate the temperature distribution within the both pre‐ and postoptimization core structure. The flow matching inlet condition and the average velocity inlet condition were considered. The results showed that to eliminate hot spots, a flow matching design is needed; otherwise, the temperature will rise greatly. Then the lifetime of graphite was calculated by combining fast neutron flux and temperature. Under average velocity inlet condition, graphite lifespan in CORE550‐20 increased from 11.4 years of the unoptimized core to 18.9 years of the optimized core, only representing a 66% enhancement due to higher temperatures. Under flow matching conditions, the lifespan of graphite in CORE450‐00 can be extended from 13.3 years of the unoptimized core to 26.8 years of the optimized core, indicating a 102% improvement.