Application of BRFP New-Type Anchor Cable Material in High Slopes against Earthquakes

Abstract

To clarify the feasibility of BFRP (basalt fiber reinforced plastics) anchors instead of steel anchors in the seismic application of slopes under different vibration strengths, a series of shaking table tests were carried out to strengthen the slope using BFRP anchors and steel anchors, respectively. By studying the dynamic response recorded in the slope model and the observed experimental phenomena, the acceleration dynamic response and displacement spectrum dynamic response of the two slope models were analyzed. The test results show that the deformation stage of the slope reinforced by the two types of anchors is basically the same during the test, that is, elastic, plastic (potential sliding surface and plastic strengthening), and failure stages, respectively. The slope is in the elastic stage before the 0.2 g seismic wave, and it gradually enters the plastic stage after the 0.4 g seismic wave. However, the peak acceleration and displacement of the slope reinforced by steel anchors are greater than those of the slope reinforced by BFRP anchors under the same working conditions of seismic waves. In addition, we found that the acceleration response spectrum distribution curve of each measuring point in the short period has an obvious amplification effect along the elevation, and its predominant period has a forward migration phenomenon with the increase of the height of the measuring point, which also indicates that the higher frequency seismic wave has a greater impact on the top of the slope. The BFRP anchors, as a kind of flexible structure supporting slope, can effectively reduce the impact of seismic waves on the slope and attenuate seismic waves to a certain extent compared with steel anchors. Furthermore, the BFRP anchors can be deformed in coordination with the slope, which can improve the overall working performance of the slope, especially limit the dynamic response of the middle and lower slopes. These results can provide a theoretical guide for the seismic design of BFRP anchors for high slopes.