Fabrication of a Microtubular La0.6Sr0.4Ti0.2Fe0.8O3−δMembrane by Electrophoretic Deposition for Hydrogen Production-Reference-Cited by-同舟云学术

Fabrication of a Microtubular La0.6Sr0.4Ti0.2Fe0.8O3−δMembrane by Electrophoretic Deposition for Hydrogen Production

Published:2015 Issue: Volume:2015 Page:1-6
ISSN:1687-8434
Container-title:Advances in Materials Science and Engineering
language:en
Short-container-title:Advances in Materials Science and Engineering

Author:

Lee Kyoung-Jin¹,Choe Yeong-Ju¹,Lee Jun-Sung¹,Hwang Hae-Jin¹

Affiliation:

1. Department of Materials Science and Engineering, Inha University, 253 Yonghyun-dong, Nam-gu, Incheon 402-751, Republic of Korea

Abstract

Microtubular type La0.6Sr0.4Ti0.2Fe0.8O3−δ(LSTF) membranes were prepared by electrophoretic deposition (EPD). The oxygen permeation and hydrogen production behavior of the membranes were investigated under various conditions. LSTF green layer was successfully coated onto a carbon rod and, after heat treatment at 1400°C in air, a dense LSTF tubular membrane with a thickness of 250 mm can be obtained. The oxygen permeation and hydrogen production rate were enhanced by CH4in the permeate side, and the hydrogen production rate by water splitting was 0.22 mL/min·cm2at 1000°C. It is believed that hydrogen production via water splitting using these tubular LSTF membranes is possible.

Funder

Korea Institute of Energy Technology Evaluation and Planning

Publisher

Hindawi Limited

Subject

General Engineering,General Materials Science

Link

http://downloads.hindawi.com/journals/amse/2015/505989.pdf

Reference10 articles.

1. The properties of hydrogen as fuel tomorrow in sustainable energy system for a cleaner planet

2. Perovskite membrane reactor for continuous and isothermal redox hydrogen production from the dissociation of water

3. Hydrogen production by water dissociation using mixed conducting dense ceramic membranes