Corrosion Evaluation of Pure Mg Coated by Fluorination in 0.1 M Fluoride Electrolyte

Abstract

In the ongoing research on the application of biodegradable materials, surface treatment of is considered to be a relatively effective solution to the excessive degradation rates of Mg alloys. In this study, to further optimize the proven effective surface coatings of fluoride, a low-voltage preparation fluorination method was used to achieve coating effectiveness under safer conditions. Optical observation, scanning electron microscopy (SEM), X-ray diffraction (XRD), energy-dispersive spectroscopy (EDS), and potential dynamic polarization (PDP) experiments were used for the analysis and evaluation. The coating characteristics of the MgF2 coatings treated in the 10–90 V voltage range, including the structure, chemical conformation, and electrochemical corrosion assessment, were fully defined. The anodic fluoridation results showed that a pore structure of 1–14 μm thickness was formed on the Mg alloy substrate, and the coating was composed of Mg fluoride. The results of immersion corrosion and electrochemical corrosion experiments showed that compared with pure Mg, anodic fluorinated samples below 40 V exhibited better corrosion resistance, the prepared MgF2 coating was more uniform, and the surface mostly exhibited point corrosion. When the voltage reached or exceeded 60 V, the prepared coating exhibited poor corrosion resistance, fracture, and protrusions. After corrosion, it mostly exhibited surface corrosion. The results indicate that idealized coatings can be obtained at relatively low and safe voltage ranges. This finding may enable more economical, environmentally friendly, and safe preparation of coatings.