Experimental Investigation of Plastic Flow in Rails for a Laboratory Wheel Rail Simulation-Reference-Cited by-同舟云学术

Experimental Investigation of Plastic Flow in Rails for a Laboratory Wheel Rail Simulation

Published:1982-01 Issue:1 Volume:21 Page:59-66
ISSN:0008-4433
Container-title:Canadian Metallurgical Quarterly
language:en
Short-container-title:Canadian Metallurgical Quarterly

Author:

Kumar S.,Aronov V.,Rajkumar B. R.,Margasahayam R.

Publisher

Informa UK Limited

Subject

Industrial and Manufacturing Engineering,Metals and Alloys

Link

http://www.tandfonline.com/doi/pdf/10.1179/cmq.1982.21.1.59

Reference13 articles.

1. S. Kumar and B. R. Rajkumar, AREA Bull. No. 679 (September 1980).

2. W. S. Pellini, Mechanical Metallurgy Factors in the Wear of Wheel-Rail Interfaces, Provisional Draft of Consultant Report, Association of American Railroads Technical Center (1976).

3. A review of the theory of rolling contact stresses

4. An Analysis of Plastic Deformation in Rolling Contact

5. Plastic Flow in Rollers Loaded above the Yield Point

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental and Numerical Visualisation of Subsurface Rail Deformation in a Full-Scale Wheel–Rail Test Rig;Metals;2023-06-08

2. Deformation and Microstructural Evolution of Nanostructured Pearlite under Tension versus Torsion;steel research international;2020-12

3. Prediction of plastic deformation and wear in railway crossings – Comparing the performance of two rail steel grades;Wear;2019-06

4. Deterioration mechanisms in the wheel–rail interface with focus on wear prediction: a literature review;Vehicle System Dynamics;2009-06

5. Ratchetting strain experiments with a pearlitic steel under rolling/sliding contact;Wear;1997-04