Process parameters survey in milling with various tooth cutters-Reference-Cited by-同舟云学术

Process parameters survey in milling with various tooth cutters

Published:2022-12-19 Issue:12 Volume:2022 Page:21-26
ISSN:2223-4608
Container-title:Science intensive technologies in mechanical engineering
language:en
Short-container-title:

Author:

Unyanin Aleksandr¹,Chudnov Aleksandr²

Affiliation:

1. Ulyanovsk State Technical University

2. Ul'yanovskiy gosudarstvennyy tehnicheskiy universitet

Abstract

The obtained analytical dependences, which allow determining the parameters of flank milling and peripheral milling using butt mills with various tooth cutters are presented. Computer simulation using these dependencies allows revealing of regularity in cut geometric parameters change, cutter force and friction load, as well as temperatures in the interface of the cutter tooth with facing and rough piece and also in the strand shell depending on the duration of the cutter tooth contact with the workpiece surface and the teeth distance

Publisher

Bryansk State Technical University BSTU

Subject

General Earth and Planetary Sciences,General Environmental Science

Reference10 articles.

1. Khramov, A.V. Improving the performance of the processing of deep holes by improving the structure of the boring tool // IOP Conference Series: Materials Science and Engineering. – 2019. – 709 044068. Vol. 3., Khramov, A.V. Improving the performance of the processing of deep holes by improving the structure of the boring tool // IOP Conference Series: Materials Science and Engineering. – 2019. – 709 044068. Vol. 3.

2. Особенности импортозамещения металлорежущего инструмента в современных условиях / А.В. Храмов, Е.Н. Лексин, И.В. Семдянкин, М.В. Назаров, Е.С. Киселев // СТИН, 2016. – №1. – С. 21-26., Osobennosti importozamescheniya metallorezhuschego instrumenta v sovremennyh usloviyah / A.V. Hramov, E.N. Leksin, I.V. Semdyankin, M.V. Nazarov, E.S. Kiselev // STIN, 2016. – №1. – S. 21-26.

3. Резников, А.Н., Резников, Л.А. Тепловые процессы в технологических системах. – М.: Машиностроение, 1990. – 288 с., Reznikov, A.N., Reznikov, L.A. Teplovye processy v tehnologicheskih sistemah. – M.: Mashinostroenie, 1990. – 288 s.

4. Унянин, А.Н. Аналитическое исследование температурного поля при фрезеровании с наложением ультразвуковых колебаний // Вестник РГАТУ им. П.А. Соловьева. – 2017. – № 2 (41). – С. 220-235., Unyanin, A.N. Analiticheskoe issledovanie temperaturnogo polya pri frezerovanii s nalozheniem ul'trazvukovyh kolebaniy // Vestnik RGATU im. P.A. Solov'eva. – 2017. – № 2 (41). – S. 220-235.

5. Бобров, В.Ф. Основы теории резания металлов. – М.: Машиностроение, 1975. – 344 с., Bobrov, V.F. Osnovy teorii rezaniya metallov. – M.: Mashinostroenie, 1975. – 344 s.