Affiliation:
1. Automotive Engineering Department, Belarusian National Technical University, Belarus, Minsk, Belarus
2. Technical University of Ilmenau, Ilmenau, Germany
Abstract
Up-to-date automotive brake systems place stringent requirements upon the performance, reliability, and active safety. Such advanced systems as antilock braking systems (ABS), the electronic stability programme system, and the anti-slip control system assist a driver in ensuring driving safety under many conditions. The influence of the brake components on active safety systems is mainly determined through the hysteresis loop width. Among other negative outcomes, this parameter limits the possible frequency of cyclic braking during ABS operation. This paper presents an experimental analysis of the factors influencing the hysteresis pressure losses in a hydraulic brake system. The factors under investigations are the brake pedal stroke velocity, the gaps between the brake pads and the brake disc, and the configuration of the brake system. Experiments were carried out on the brake test equipment at the Automotive Engineering Department, Faculty for Mechanical Engineering, Technische Universität Ilmenau, Germany.
Subject
Mechanical Engineering,Aerospace Engineering
Reference10 articles.
1. Defining the Optional Geometry of Proportional Valve Using Computer Simulation
2. A study of the effects of entrained air in a hydraulic brake actuator
3. 7 Ren L., Chen H., Wang T. Dynamic system identification of Audi disc brake under anti-lock condition. In Proceedings of the IEEE International Vehicle Electronics Conference (IVEC 1999), 6-9 September 1999, vol. 1, pp. 78–81 (IEEE, New York).
4. 8 Dupuis V. Development of new drum brake. In Proceedings of the 25th International μ-Symposium - Brake Conference, Bad Neuenahr, Germany, 17-18 June 2005, pp. 95–101 (VDI Publishing, Düsseldosf).
Cited by
6 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
1. Development of Instantaneous Braking System for Rotating Members;The International Conference on Processing and Performance of Materials (ICPPM 2023);2024-01-30
2. Considerations for the Design of a Wheelchair Dynamometer Concerning a Dedicated Braking System;Applied Sciences;2023-06-23
3. Passenger car active braking system: Model and experimental validation (Part I);Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science;2017-01-06
4. Identification and characterization of the hydraulic unit in an anti-lock brake system;Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering;2016-08-06
5. A dynamic model for brake pedal feel analysis in passenger cars;Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering;2015-08-18