Design formula for grooved shafts under torsion-Reference-Cited by-同舟云学术

Design formula for grooved shafts under torsion

Published:1986-10-01 Issue:4 Volume:21 Page:205-211
ISSN:0309-3247
Container-title:The Journal of Strain Analysis for Engineering Design
language:en
Short-container-title:The Journal of Strain Analysis for Engineering Design

Author:

Kato A¹

Affiliation:

1. Department of Mechanical Engineering, Chubu University, Japan

Abstract

A design formula has been derived to estimate stress concentration factors of grooved shafts with several kinds of groove shapes. This formula was based on the analytical result for infinitesimal grooves and for finite grooves the experimental values found by the author and others, with the numerical values found by other investigators. Over a wide range of groove sizes, the formula agrees fairly well with the numerical values of Nishitani et al. Comparison with Neuber's formula shows that his formula gives much lower values than the present one, especially for deep grooves.

Publisher

SAGE Publications

Subject

Applied Mathematics,Mechanical Engineering,Mechanics of Materials,Modelling and Simulation

Link

http://journals.sagepub.com/doi/pdf/10.1243/03093247V214205

Reference12 articles.

1. Stress Concentration Factors of Semi-Circular Grooves in Torsion

2. Stress concentration factors of grooved shafts in torsion

3. Stress Concentration Factors for the Torsion of Shafts with a Circumferential Semi-Elliptic Groove

4. Torsion of a Cylindrical Bar Having a Semi-Elliptical or a 60° V-Shaped Circumferential Groove

5. Solution of axisymmetric torsion problems by point matching

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Shafts with U-shaped circumferential grooves: design charts for stress concentration factors, radial displacement and Poisson’s ratio influence;Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science;2022-05-13

2. Stress concentrations in periodic notches: a critical investigation of Neuber's method;Materialwissenschaft und Werkstofftechnik;2013-05

3. Torsional stress distributions in tubes with external and internal notches;The Journal of Strain Analysis for Engineering Design;2012-06-21

4. Concentration of shear stresses in shallow periodic notches;The Journal of Strain Analysis for Engineering Design;2011-06-27

5. Stress fields due to inclined notches and shoulder fillets in shafts under torsion;The Journal of Strain Analysis for Engineering Design;2011-04