Modelling and optimization of part-flow evaporative gas turbine cycles-Reference-Cited by-同舟云学术

Modelling and optimization of part-flow evaporative gas turbine cycles

Published:2005-11-01 Issue:7 Volume:219 Page:533-548
ISSN:0957-6509
Container-title:Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy
language:en
Short-container-title:Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy

Author:

Yari M¹²,Sarabchi K¹

Affiliation:

1. Department of Mechanical Engineering, University of Tabriz, Tabriz, Iran

2. Faculty of Engineering, University of Mohaghegh Ardabili, Ardabil, Iran

Abstract

The evaporative gas turbine cycle is a new high-efficiency power cycle that has reached the pilot plant testing stage. This article presents the construction of a mathematical model for thermodynamic simulation of part-flow evaporative gas turbine cycle including steam injection. The maximum deviation of predicted performance results by this model from available data in literature was 1 per cent. Then, changes in configuration of this cycle have been investigated. Configuration changes concern using feed water heater and injection of saturated vapour instead of superheated vapour to the humid air in the cycle. This investigation shows that both these strategies were in the direction of improvement of efficiency and specific work of cycles (intercooled and non-intercooled). The results obtained from this research show that using spray cooler as the intercooler in the intercooled cycle offers interesting perspectives. In addition, the optimization of part-flow evaporative gas turbine (PEvGT) cycles in the systematic manner is presented and discussed.

Publisher

SAGE Publications

Subject

Mechanical Engineering,Energy Engineering and Power Technology

Link

http://journals.sagepub.com/doi/pdf/10.1243/095765005X31315

Reference24 articles.

1. Augmentation of gas turbine performance using air coolers

2. An Assessment of the Thermodynamic Performance of Mixed Gas–Steam Cycles: Part B—Water-Injected and HAT Cycles

3. Effects of evaporative inlet and aftercooling on the recuperated gas turbine cycle

4. Performance improvements of the intercooled reheat recuperated gas-turbine cycle using absorption inlet-cooling and evaporative after-cooling

5. Thermoeconomic analysis of mixed gas–steam cycles

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Thermoenvironomic evaluation of simple, intercooled, STIG, and ISTIG cycles;International Journal of Energy Research;2018-06-11

2. A multi-featured model for estimation of thermodynamic properties, adiabatic flame temperature and equilibrium combustion products of fuels, fuel blends, surrogates and fuel additives;Energy;2018-01

3. The Sustainable Option of Power from Fossil Fuels with Carbon Capture and Storage: An Overview of State-of-the-Art Technology;Sustainable Energy Technology and Policies;2017-12-22

4. Thermodynamic, environmental and economic performance optimization of simple, regenerative, STIG and RSTIG gas turbine cycles;Energy;2017-02

5. Performance and environment as objectives in multi-criterion optimization of steam injected gas turbine cycles;Applied Thermal Engineering;2014-10