Control of chip flow direction in high-pressure water jet-assisted orthogonal tube turning-Reference-Cited by-同舟云学术

Control of chip flow direction in high-pressure water jet-assisted orthogonal tube turning

Published:2000-07-01 Issue:7 Volume:214 Page:529-534
ISSN:0954-4054
Container-title:Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
language:en
Short-container-title:Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture

Author:

Kaminski J¹,Ljungkrona O¹,Crafoord R¹,Lagerberg S²

Affiliation:

1. Chalmers University of Technology Department of Production Engineering Göteborg, Sweden

2. Sandvik Coromant Sankviken, Sweden

Abstract

This paper shows the possibility of controlling the chip side-flow direction in water jet-assisted turning using flat-faced inserts without any chip formers. The experiments were performed under orthogonal cutting conditions of an end of a pipe with plain water jet assistance with a pressure up to 80 MPa and a flow up to 81/min. The jet was directed perpendicular to the cutting edge into the tool/chip interface. Experimental results show that the chip side-curl radius can be successfully controlled. A correlation between the jet momentum, jet diameter and side-curl radius is presented and widely discussed.

Publisher

SAGE Publications

Subject

Industrial and Manufacturing Engineering,Mechanical Engineering

Link

http://journals.sagepub.com/doi/pdf/10.1243/0954405001518224

Reference8 articles.

1. Kaminski J., Alvelid B. High pressure cooling of cutting area for machining of modern materials. In Proceedings of the International Conference on Challenges to Civil and Mechanical Engineering in 2000 and Beyond, Wroclaw, Poland, June 1997.

2. Recent Developments in Chip Control Research and Applications

3. On the Controllability of Chip Breaking Cycles and Modes of Chip Breaking in Metal Machining

Cited by 27 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Fundamental characterization of lubrication effects through various cooling lubricants in the chip formation zone;Production Engineering;2024-08-01

2. Elemental Composition, Phase Diagram, Microstructure, Fabrication Processes, and Mechanical Properties of Ti2AlNb Alloy: A Review;Journal of Materials Engineering and Performance;2024-07-08

3. On modelling coolant penetration into the microchannels at the tool-workpiece interface;Journal of Manufacturing Processes;2022-12

4. The Research on Tool-Chip Contact Length for Cutting Superalloy under High Pressure Cooling;Integrated Ferroelectrics;2022-06-03

5. Turning of steels under various cooling and lubrication techniques: a review of literature, sustainability aspects, and future scope;Engineering Research Express;2021-11-17