Aerodynamics and Heat Transfer of Swirling Natural Gas Flow in a Vortex Heat Exchanger of the Heating System of a Gas Control Point-Reference-Cited by-同舟云学术

Aerodynamics and Heat Transfer of Swirling Natural Gas Flow in a Vortex Heat Exchanger of the Heating System of a Gas Control Point

Published:2020-12-06 Issue:3 Volume:24 Page:99-110
ISSN:2686-6757
Container-title:Proceedings of the Southwest State University
language:
Short-container-title:Proceedings of the SWSU

Author:

Grigorova N. P.¹,Monastyrev P. V.²,Pakhomova E. G.¹,Semicheva N. E.¹

Affiliation:

1. Southwest State University

2. Tambov State Technical University

Abstract

Purpose of research. To obtain a two-parameter model characterizing the aerodynamic and heat exchange processes occurring in a vortex heat exchanger, giving a better agreement between the calculated and experimental values of the heat transfer coefficient taking into account the curvature of the swirling gas flow in a vortex heat exchanger, in which a controlled gas pressure drop is used as a source of thermal energy. This technical solution will make it possible to abandon the installation of autonomous sources of thermal energy, which will reduce the cost of gas as a fuel in the heating system of the industrial premises of the gas distribution point (GDP), as well as provide more comfortable working conditions for the hydraulic fracturing pressure regulator. Methods. Comprehensive analysis of thermal and hydraulic characteristics in a vortex heat exchanger is based on well-known theoretical positions and equations of motion of a swirling gas flow and heat exchange laws. Results. It is obtained a dependence that characterizes the intensification of heat transfer based on the influence of the axial and rotational speed, as well as the path of motion of the swirling gas flow. This dependence is obtained on the basis of a comprehensive analysis of the aerodynamic and heat exchange characteristics of a vortex heat exchanger, in which a controlled gas pressure drop is used as a source of thermal energy. Conclusion. The obtained two-parameter model gives the best agreement of the calculated values of the heat transfer coefficient with the values obtained experimentally, which were used in the thermal engineering calculation of the design parameters of the vortex heat exchanger.

Publisher

Southwest State University

Subject

General Earth and Planetary Sciences,General Engineering,General Environmental Science

Reference20 articles.

1. Dubrakova K. O., Monastyrev P. V., Klychnikov R. Y., Yezerskiy V. A. Optimization of thermal modernization of a group of buildings using simulation modeling. Journal of Applied Engineering Science, 2019, vol. 17, is. 2, pp. 192-197.

2. Mishchenko E., Monastyrev P., Evdokimtsev O. Quality Improvement of Specialists Training for Energy-Efficient Construction. 2018 IOP Conf. Ser.: Mater. Sci. Eng. 463 032046. https://doi.org/10.1088/1757-899X/463/3/032046

3. Erofeev A.V., Yartsev V. P., Monastyrev P. V. Dekorativno-zashchitnye plity dlya fasadnoi otdelki zdanii [Decorative and protective plates for facade finishing of buildings. News of higher educational institutions]. Izvestiya vysshikh uchebnykh zavedenii. Tekhnologiya tekstil'noi promyshlennosti = Technology of the Textile Industry, 2017, no. 1 (367), pp. 101-104 (In Russ.).

4. Gusev B. V., Yezersky V. A., Monastyrev P. V. Teploprovodnost' mineralovatnykh plit v usloviyakh ekspluatatsionnykh vozdeistvii [Thermal conductivity of mineral wool slabs under operating conditions]. Promyshlennoe i grazhdanskoe stroitel'stvo = Industrial and Civil Construction, 2005, no. 1, pp. 48-49 (In Russ.).

5. Gusev B. V., Yezersky V. A., Monastyrev P. V. Izmenenie lineinykh razmerov mineralovatnykh plit v usloviyakh ekspluatatsionnykh vozdeistvii [Changing the linear dimensions of mineral wool slabs under operating conditions]. Promyshlennoe i grazhdanskoe stroitel'stvo = Industrial and Civil Construction, 2004, no. 8, pp. 32-34 (In Russ.).