Theory of Filler Reinforcement

Abstract

Abstract For small loadings (up to about 10 per cent volume parts) colloidal carbon-black spheres may be considered as suspended in a continuous rubber matrix. In the present paper this model is generalized for ellipsoidal (including plate-like and rodlike) filler particles, and it is extended to the computation of various properties of the suspension in terms of the properties of the matrix and of the fillers. Viscosity, Young's modulus, stress-strain curve below crystallization and dielectric constant of the suspension are derived as linear functions of the volume concentration for small, and as quadratic functions for higher loadings. The stress-strain curves for varying proportions of fillers are similar. For small loadings the tensile strength first decreases because of the stress concentrations around the carbon-black spheres when the samples are stretched. The increase in tensile strength observed for greater loadings is caused by the tendency of the carbon-black spheres to form chains and, finally, a type of network. The stiffness increases with loading up to the point where the suspension becomes a dilution of carbon black by rubber. There the tensile strength decreases too. Binding of rubber by carbon black is similar to solvation. The theoretical conclusions were checked experimentally ; in particular, the dependence of Young's modulus on concentration, the similarity of stress-strain curves, and the decrease of the tensile strength for small loadings. The theory of the elastic properties is very similar to the theory of Einstein on the viscosity of colloidal solutions and to Maxwell's and Rayleigh's theory of dielectric properties.