Method of scanning thin surfaces in repairing gas turbine blades-Reference-Cited by-同舟云学术

Method of scanning thin surfaces in repairing gas turbine blades

Published:2023-12-28 Issue:4 Volume:22 Page:112-124
ISSN:2541-7533
Container-title:VESTNIK of Samara University. Aerospace and Mechanical Engineering
language:
Short-container-title:VESTNIK of Samara University. Aerospace and Mechanical Engineering

Author:

Kotlyar D. I.,Lomanov A. N.

Abstract

Improving the efficiency of weld overlay repair of gas turbine blades by developing and implementing a method of scanning complex curved surfaces of gas turbine blades directly on the machine is the aim of this work. The paper proposes an approach to scanning a blade with a computer vision system mounted near the nozzle on the same machine that is used for direct metal deposition. The computer vision system consists of a triangulation laser sensor and a camera. The proposed algorithm is adaptive to the mechanical condition of the equipment used for scanning and metal deposition. The scans obtained from the machine vision system have precision better than 0.05mm in 67.56% of cases, and precision better than 0.1mm in 95.75% of cases. That accuracy, with a laser spot of 0.5 to 1.0mm, is sufficient for further use of the scans in repairing gas turbine blades. The proposed approach makes it possible to speed up the preparation of technological programs for direct metal deposition by 10 times compared to the manual scanning method.

Publisher

Samara National Research University

Subject

Ocean Engineering

Reference30 articles.

1. Analysis and directions of technological and organization problem updating in gas turbine aircraft engine repair

2. Leontev V.A., Zilichikhis S.D., Kondratyuk E.V., Zamkovoy V.E. Restoration of gas turbine engine performance using new technologies and materials. Vestnik Dvigatelestroeniya. 2006. No. 4. P. 99-103. (In Russ.)

3. Bessudnov I.A. Sovershenstvovanie tekhnologiy remonta gazoturbinnykh aviatsionnykh dvigateley s ispol'zovaniem resursosberegayushchikh tekhnologiy. Dis. … kand. tekhn. nauk [Improvement of repair technologies for gas turbine aircraft engines using resource-saving technologies. Ph.D thesis in Engineering Science]. Rybinsk, 2014. 208 p.

4. Semi-automatic Low Cost 3D Laser Scanning Systems for Reverse Engineering

5. Ahmadi S.A., Mohammadzadeh A., Hosseininaveh A. Introduction of a domestic scanner for 3D object modeling and its evaluation. 1st National Conference on Geospatial Information Technology (January, 19-20 января, 2016, Tehran, Iran).