The wetting‐to‐nonwetting transition of CVD BN coatings deposited at different temperatures

Abstract

AbstractBoron nitride (BN) coatings (thickness 20–40 μm) were prepared on graphite substrates by chemical vapor deposition, with precursors of BCl3 and NH3 (ratio of 1:4) and pressure of 500 ± 50 Pa. The influence of the deposition temperature (650°C–1250°C) on the wettability of BN coatings with deionized water was studied. The wetting angle rapidly increases at 1100°C–1250°C, and the wetting‐to‐nonwetting transition occurs. The crystal structure and surface morphology of the BN coatings were characterized by a stylus instrument, scanning electron microscopy, and transmission electron microscopy. Research shows that the contact angle or nonwettability increases with a higher degree of crystallinity and a lower surface roughness, which were both under the control of the deposition temperature since the pressure and gas flows were kept constant in this study. At a deposition temperature of 650°C–950°C, the increase in the degree of crystallinity dominates; at 950°C–1100°C, the increase in surface roughness takes over. At 1100°C–1250°C, the degree of crystallinity continues to increase, while the surface roughness decreases due to the advantage of nucleation and the breakage of large surface clusters into smaller clusters. This results in increases (650°C–950°C), then decreases (950°C–1100°C) and again fast increases (1100°C–1250°C) in the wetting angle between the BN coating and deionized water and finally in the wetting‐to‐nonwetting transition (1100°C–1250°C).