Affiliation:
1. Materials Measurement Sciences Division National Institute of Standards and Technology Gaithersburg Maryland USA
2. Ceramic and Polymer Composites Branch NASA Glenn Research Center Cleveland Ohio USA
3. Weapons and Materials Research Directorate U.S. Army Research Laboratory Aberdeen Proving Ground Maryland USA
Abstract
AbstractWe have evaluated over fifty materials using small semi–elliptical controlled surface flaws with the Newman–Raju factors. Although occasionally there were nuances and peculiarities, the results were sound and comparable to other methods. So, despite the lengthy discussions and numerous plots in Lubauer et al.’s paper, what is evident is that if one simply follows the guidelines in ASTM C 1421 and the other standards for most ceramics including the SL200B sintered silicon nitride, and polish off the recommended 4.5 to 5 h material, one will obtain the correct results. Excessive indentation forces and excessive material removal to obtain sharp corner, shallow surface cracks are unwise. Removing more than 5 h should only be done to remove lateral cracks. In such cases the Strobl et al. solutions may be useful. These solutions are an interesting alternative to the reputable Newman–Raju factors, but much more experience and verification is needed before they can be accepted. They and the extension of their analysis for precrack angles χ < 70° need to be vetted in a major engineering journal.
Subject
Materials Chemistry,Ceramics and Composites
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献