Fracture of all‐oxide ceramic composites: Crack path analysis by surface strain monitoring

Abstract

AbstractCrack propagation in ceramic matrix composites is very difficult to observeand to quantify. To investigate crack formation in all‐oxide ceramic composites, single edge notched bending tests were performed including loading‐unloading cycles and online monitoring of surface deformation using digital image correlation. The crack length was calculated by the compliance method with the crack opening displacement determined optically using digital image correlation. Obtained crack length values were found to be too small considering the sample geometry. Secondly, surface strain monitoring was used to investigate the crack growth. Analysis of cyclic force‐crack opening displacement curves and the results from strain monitoring indicated no major crack growth for loads below maximum force but still a moderately decay of force after onset of cracking. Graphical analysis of the surfaces of broken samples showed crack flank lengths ranging from 3 to 6 mm. Due to highly individual crack deflection mechanisms throughout the thickness of the oxide ceramic composites, deviations between front and back of specimens are found. The results demonstrate the necessity to use individual crack length measurements of each specimen for quantitative fracture mechanical evaluation. Strain monitoring during testing was shown to be a valuable tool for online crack path investigation.